[. . . ] 7 cm) from top of countertop to bottom of cutout CUTOUT DIMENSIONS Oven Size 24" (61 cm) 27" (68. 6 cm) For the approved model number combinations, refer to the undercounter label located on top of the oven chassis and on the bottom of the cooktop burner box. [. . . ] NOTE: For undercounter installation, it is recommended that the junction boxes for oven and cooktop be located in the adjacent right or left cabinet. 5 cm) minimum diameter hole should have been drilled in the upper rear right or left corner of the side wall surface to pass the appliance cable through to the junction box. On models with Steam-Assist, it will be necessary to drill a ½" (1. 3 cm) minimum diameter hole in the upper right or left rear corner of the side wall to pass the water supply tubing through to the undersink water filter. If water supply tubing hole is drilled on the same side as the oven cable hole, a minimum of 2" (5. 4 cm), dimension “G” can be increased the same difference for induction combinations. On models with Steam-Assist, it will be necessary to drill a ½" (1. 3 cm) minimum diameter hole in the upper right or left rear corner of the side wall to pass the water supply tubing through to the undersink water filter. If water supply tubing hole is drilled on the same side as the oven cable hole, a minimum of 2" (5. The upper shaded areas are recommended locations for recessed junction box for 120-volt grounded outlet for cooktop. Lower shaded areas are recommended locations for flexible or rigid gas pipe installation. The gas connection on the cooktop is on the right (same location as “J” in the above diagram). [. . . ] Lower shaded areas are recommended locations for flexible or rigid gas pipe installation. The gas connection on the cooktop is on the right (same location as “J” in the above diagram). [. . . ]